A forum for discussing wooden boats and boat building
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 9 Oct 2014 9:49 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Fyne Four build
I am going to upload pictures of my Fyne four books here...
boxes and contents
Last edited by ianandwend (10 Oct 2014 6:37 am)
Offline
#2 9 Oct 2014 10:02 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Re: Fyne Four build
put together the main plants
Offline
#3 9 Oct 2014 10:04 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Re: Fyne Four build
put the hull together
Offline
#4 9 Oct 2014 10:07 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Re: Fyne Four build
fillet the hull
Offline
#5 9 Oct 2014 10:10 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Re: Fyne Four build
glass the hull
Offline
#6 9 Oct 2014 10:12 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Re: Fyne Four build
forward tank, and transom
Offline
#7 9 Oct 2014 10:15 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Re: Fyne Four build
rails
Offline
#8 9 Oct 2014 10:17 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Re: Fyne Four build
forward tank
Offline
#9 9 Oct 2014 10:19 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Re: Fyne Four build
inwales
Offline
#10 9 Oct 2014 10:21 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Re: Fyne Four build
bowsprit
Offline
#11 9 Oct 2014 10:25 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Re: Fyne Four build
last bits
Offline
#12 9 Oct 2014 10:27 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Re: Fyne Four build
mast and bits
Offline
#13 9 Oct 2014 10:28 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Re: Fyne Four build
getting the sails and rigging ready
Offline
#14 9 Oct 2014 10:30 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Re: Fyne Four build
ready to go
Offline
#15 9 Oct 2014 10:31 pm
- ianandwend
- Member
- Registered: 9 Oct 2014
- Posts: 15
Re: Fyne Four build
and finally on the water
Offline
#16 10 Oct 2014 9:12 am
- wilddog
- Member
- From: Devon
- Registered: 22 Dec 2013
- Posts: 143
Re: Fyne Four build
A fine looking craft! Well done!
Built a Skerry!
Offline
#17 1 Sep 2020 9:35 am
- nicgel
- Member
- Registered: 8 Aug 2020
- Posts: 3
Re: Fyne Four build
I am building a Stornoway 12' sailing dinghy. I was interested in the fibreglassing aspect of the build. I noticed that the outside fibreglassing on this build was up to the edge of the flat part of the bottom of the boat and the inside sheathing was up to the edge of the buoyancy tanks.
I also noticed that there was no fibreglass tape in the upper planks above either the two fibreglass sheaths inside and outside. I would have thought that at least fibreglass tap should be laid down on at least the inside of the seam and filleting on the outside. Paul Fisher recommends this. So should I do this if I follow the sheathing done on this build?
Offline
#18 2 Sep 2020 7:39 am
- Paul
- Employee
- From: Gatebeck Cumbria
- Registered: 4 Aug 2011
- Posts: 132
Re: Fyne Four build
You should certainly follow the advice of the designer Paul Fisher. The side panels of the above boat are cut differently and there is a joint between the panels which is why there is no need for fabric.
Offline
#19 2 Sep 2020 8:23 am
- nicgel
- Member
- Registered: 8 Aug 2020
- Posts: 3
Re: Fyne Four build
Perfect. Just the advice I needed.
Offline
Pages: 1