The lowest 2 planks of wont come together close enough at the ends to fit in the grooves on the end of the transoms. This means that the remaining planks wont fit on the transoms. The planks fit otherwise. I have given it several days and tightened up the ties several times. I then tried cable ties as I am effectively doing this on my own and they are easier to tighten. There has been some improvement but I cant get the last 3mm or so at the ends which I need To fit them. I am considering removing a small amount from the upper edge of the first 2 planks to allow them to fit the transom. The rebate is on the lower edge of the plank and there is lots of overlap so I would have thought this should be secure when epoxied but I would welcome any thoughts?
]]>